VACUUBRAND VNC 2 E User Manual
Page 24
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999199 / 28/11/2012
Displays in basic mode ”Vacuum control”
Pressure > upper value of hysteresis:
Pressure within preset limits:
After exceeding of upper pressure value:
After expiry of process time:
Key ”ENTER” pressed:
Key ”ENTER” and key t pressed:
Key ”ENTER” and key s pressed:
Key t pressed for less than 2s:
Key t pressed for longer than 2s:
Key t pressed for longer than 2s and key
”ENTER” pressed additionally:
Key s pressed for less than 2s:
Key s pressed for more than 2s:
Displays in basic mode ”Continuous pumping”
Operating with valve:
Key ”ENTER” pressed:
Key ”ENTER” and key t pressed:
In remote mode:
P
is displayed in the second line.
Pump down
-> p <-
Stopped
Timeout
Pause
(valve closed)
p Set
(actual pressure value is stored as
preset value)
∆p (actual pressure is stored as upper pressure
value)
xxxxmbar
(preset pressure is displayed)
Adapt p
(Pump / valve starts, preset pressure is
adjusted)
Pumpdown
(switching to mode ”Continuous pumping”)
xxxxmbar
(pumping down interrupted, pause)
Adapt p
(preset pressure is adjusted), venting
Status messages displayed during operation of a program
The messages are always displayed in the second line, the first line always displays the pressure
value.
Pumpdown
Pause
(valve closed)
p Set
(actual pressure value is stored as preset
value, switching to vacuum control)