USL CCE-100 - Manual (Page 4)

CCE-100 INSTRUCTION MANUAL Ultra Stereo Labs, Inc.
- 6 -
CCE-100 INSTRUCTION MANUAL Ultra Stereo Labs, Inc.
- 7 -
1. Power supply
, 12VDC, 1.2A.
2. USB data duplicates RS232. Used for debug and configuration. 3. Ethernet. Connect to Digital Cinema Server control network. 4. Restore button. Use a paperclip to press button during powerup to restore original firmware and default configuration. 5. RS232 port. Connect Rear Window
®
display or use null modem cable to connect a terminal for debug and configura-
tion. 6. RF to IRC-28. If an IR panel is used to transmit captions, run a 75 ohm coaxial cable from this connector to the RF IN connector on an IRC-28. 7. Wi-Fi antenna. If the optional Wi-Fi module is installed, connect an antenna in the auditorium to this connector to provide captions to Wi-Fi devices. 1. PWR. Lit when power is applied and the processor is running. Flickers during firmware restore. 2. DCS LINK. Lit when CCE-100 connects to the Digital Cinema Server (DCS) using the
Auxiliary Content Synchroniza-
tion Protocol. 3. RPL
FETCH. Lit when the CCE-100 is fetching an
Auxiliary Resource Presentation List (RPL) file from the DCS.
4. RPL
P
ARSE. Lit when the CCE-100 is parsing data from the RPL.
5.
TIMED
TEXT
FETCH. Lit when the CCE-100 is fetching timed text (caption text) from the DCS.
6.
TIMED
TEXT
P
ARSE. Lit when the CCE-100 is parsing a timed text file and preparing captions for display
.
7-9. LANGUAGE READY
. When some caption data for each language is ready for display
, the corresponding LED is lit.
Not all content has three languages, so all three LEDs may not light. 10. CAPTION
TX.
T
oggles when the next caption is transmitted to the display device.
1
1. DA
T
A
OUT
. Lit when the DCS has sent the “set output mode enabled” command over the
Auxiliary Content Synchro
nization Protocol link.
The DCS has started playing content that includes auxiliary content such as captions.