Triner Scale T-1000 TELESET - Manual (Page 21)

37 36
Operator manual T-1000 TELESET Troubleshooting
11 Troubleshooting
If the T-1000 needs help, it lets you know with
a two-digit code and the message ‘Service’.
The tips given on the following pages will
assist you in troubleshooting.
Codes that appear with words are:
The code ‘21’ or ‘23’ with the word
‘Service’ and/or ‘Cassette’ mean a letter is in
the feed path. Press the ‘C’ key and the T-1000
will clear itself.
The message ‘Cassette’ alone means it’s time
for a new thermal ribbon cassette. Replace
the old one using directions in section 10.2.
If the message ‘Service’ appears by itself, or
with the or symbol, call your local FP
dealer.
See section 9.2 for information on the faults
and problems specific to TELESET loading.
‘Service’
‘Service’ +
10.2 Changing the ribbon cassette
The T-1000 will display the message
‘Cassette’ when it is time for a new thermal
ribbon. This is the easiest printing supply you
will ever replace. Simply open the cartridge
door by pressing the catch on the front of the
machine. Swing the door completely open
and pull out the old ribbon. To insert the new
ribbon,
1. Remove the red protective cover from the
new ribbon and check to make sure the
ribbon is tight.
2. Set the cartridge (ribbon facing down) on
the letter tray and slide into the
compartment until it stops.
3. Close the door and you’re done.
4. The ‘Cassette’ message will disappear
after you print a new envelope.