Triner Scale T-1000 TELESET - Manual (Page 16)

27 26
Operator manual T-1000 TELESET
Changing the time manually:
1. Input the new time using the number keys.
For example, the time 2:05 would be
entered ‘205’. If the entry is made
incorrectly the T-1000 will not accept it.
2. After entering the time, press the ‘Time’
key. The new time will appear in the
display together with the
symbol. The
small vertical line that appears to the left of
the displayed time indicates P.M. When the
bar is not present the displayed time is
A.M.
3. If the displayed time needs to be changed
from A.M. to P.M. or viceversa, reenter the
correct time and hold the ‘Time’ key until
the vertical line appears or disappears.
8.2 Programming ‘High postage’
High postage is a function that warns the
operator if an entered postage amount is
more than a preset limit. This amount is set at
the factory for $ 10.00, but can be easily
reprogrammed in your office. To avoid printing
high postage in error, some offices want the
‘HP’ warning at one dollar, but any amount
can be set.
1. Determine the amount at which operators
should be warned.
2. Input that amount using the number keys
and confirm your entry by pressing the
‘Set’ key.
3. The entered amount will disappear from
the display. Press the yellow ‘HP’ key.
Basic programming
4. The new high postage amount is now
programmed and the display returns to the
ready mode.
You can verify the amount set by checking
register 5 (see section 5).
8.3 Low postage warning
The ‘Limit’ indicator in the display is a
reminder that you will need to add new
postage soon. This amount is preset at the
factory for $ 100.00, but can be repro-
grammed by your servicing dealer, if
necessary.