Top Flite TOPA0951 - Manual (Page 6)

6
PREPARATION
PREPARE THE COVERING
During assembly there will be several occasions
where epoxy cleanup will be necessary. Instead of
wasting whole paper towels, stack three or four
paper towels on top of
each other and cut
them into small squares.
This will eliminate wast-
ing whole paper towels
and the little squares
are easier to use. For
epoxy clean up, damp-
en the squares with
denatured alcohol.
❏
1. Carefully remove any masking tape used for
temporarily holding parts together during shipping.
Any remaining glue from the tape can be removed
with paper towel squares dampened with naphtha
(lighter fl uid).
❏
2. Cut the covering over the air exit holes in the
ends of the rudder and elevators. These air passages
will allow expanding air to vent during the process of
tightening the covering. This will also keep the covering
KIT CONTENTS
1. Fuselage
2. Cowl
3. Replica Engine
4. Propeller Hub
5. Torque Bar
6. Fixed Landing Gear Mount
7. Main Landing Gear Wires
8. Wheel Covers
9. Wheels
10. Engine Mount
11. Fuel Tank
12. Canopy
13. Belly Pan
14. Cockpit Kit
15. Elevator Joiner Wire
16. Tail Gear Cover
17. Tail Gear
18. Horizontal Stab & Elevators
19. Rudder
20. Rudder Torque Rod
21. Right Wing Panel
22. Left Wing Panel
23. Servo Mount Blocks
24. Wing Joiners
25. Air Intakes
26. Wing Dowels
1
6
2
4
9
10
11
21
12
22
13
23 23
19
20
14
24 24
15
25 25
16
26
17
18
8
7
3
5