Toa SR-L05 - Manual (Page 9)

CAUTION
9
• Only use the stand on the flat, hard ground or floor surfaces.
• Avoid installing the stand in the passage where people could trip over
the tripod legs.
• When using the stand outdoors, avoid locations exposed to strong
winds.
• To minimize the chance of the stand toppling over, avoid extending
the stand too high.
• When the stand could fall down, be sure to secure it with guy wires or
other devices.
Connector
1. Remove front grille fixing screws (4 places) to
remove the front grille.
2. Remove horn fixing screws (8 places) to remove
the horn.
3. Disconnect connectors inside an enclosure.
4. Connect a connector having a marker on it to a
similarly marked connector, and an unmarked
connector to an unmarked connector.
5. Replace the horn using screws.
6. Replace the front grille using front grille fixing
screws.
Marker
Horn removed.
Connector
Front grille
Front grille
fixing screw
11. CHANGE FROM SINGLE- TO BI-AMPLIFIER DRIVE
The SR-F09, SR-F09-V1, SR-F09-V2, and SR-F09-V3 can be driven by bi-amplifiers if wiring of their internal
connectors is changed. When using these speakers in combination with the SR-L09, its internal wiring must
also be changed.
11.1. Changing Internal Wiring
11.1.1. SR-F09, SR-F09-V1, SR-F09-V2, and SR-F09-V3