Toa SR-L05 - Manual (Page 8)

8
10. SPEAKER STAND FOR SR-F09 AND SR-F09-V1
The speaker stand manufactured by Köning & Meyer GmbH (K & M) of Germany is made available for use
with TOA's SR-F09 and SR-F09-V1 speakers.
The speaker stand consists of a Stand and a Stand Bracket, which are sold separately.
In addition, separately prepare 2 speaker mounting screws to secure the bracket to the speaker.
Stand: Model 213
Bracket: Model 19580
Speaker mounting screw: M8 x 20
10.1. USAGE (Refer to Fig. 1.)
1. Loosen the tripod fixing screw and open the tripod
legs outward so that the stays become level.
2. Attach the stand bracket to the speaker using the
speaker mounting screws and plain washers. (Fig. 2).
3. Loosen the bracket fixing screw, then place the
speaker on the stand.
4. After setting the speaker's orientation, retighten the
bracket fixing screw.
5. Loosen the height fixing screw.
6. Loosen the handle fixing screw and raise the handle,
then retighten the handle screw.
7. While holding down the lock button, adjust the
speaker's height by turning the height adjustment
handle. (Clockwise rotation raises the speaker.)
Note: You cannot rotate the handle unless the lock button
is continuously pressed. To complete the height
adjustment, ensure that the shaft is locked when
the lock button is released. (This can be checked
by rotating the handle slightly.)
8. Retighten the height fixing screw.
9. Loosen the handle fixing screw and replace the
handle by tilting it up, then retighten the handle screw.
Leave the handle tilted up except when adjusting the
height.
10. After use, reverse the above procedures to put away
the stand.
SR-F09, SR-F09-V1
Stand bracket 19580
Speaker Stand 213
Bracket fixing screw
Height fixing screw
Tripod fixing screw
Tripod leg
Stay
Lock botton
Handle fixing screw
Height adjustment handle
Height adjuster
Plain washer
Speaker mounting screw
(to be separately prepared)
Stand bracket
(Fig. 1)
(Fig. 2)