Toa SR-L05 - Manual (Page 5)

5
7. CONNECTIONS
7.1. Combination with a Sub-woofer
INPUT
SR-F09, SR-F09-V1, SR-F09-V2, SR-F09-V3
SR-L09, SR-L05
MAIN OUT
BASS OUT
DP-0206
Digital Processor
Power amplifier
INPUT MAIN OUT
SR-F09, SR-F09-V1, SR-F09-V2, SR-F09-V3
Power amplifier
DP-0206
Digital Processor
7.2. Singular System of SR-F09, SR-F09-V1, SR-F09-V2 and SR-F09-V3
7.3. About the Power Amplifier to Connect
It is recommended that you use a power amplifier with output of over 400 W (per channel when an 8Ω load is
connected).
[SR-F09, SR-F09-V1, SR-F09-V2, SR-F09-V3] [SR-L09] [SR-L05]
• Pins of the Neutrik connector are connected as shown in the table below.
• The usable connector (on the cable end) for the NL4MPR connector is Neutrik's NL4FC.
Pin No. SR-F09, SR-F09-V1, SR-F09-V2, SR-F09-V3 SR-L09 SR-L05
1 + Speaker + - -
1 - Speaker - - -
2 + - Speaker + Speaker +
2 - - Speaker - Speaker -
6. INPUT CONNECTORS
• The figures below show each speaker's input configuration. Because the connector is internally connected in
parallel to the screw terminal, you can use either of the two.