Toa SR-TP12 - Manual (Page 14)

14
9.3. Joining the Enclosure to the Rigging Frame
Flying Plates are mounted at both the front and rear of the enclosure’s sides. Follow the procedure below to
mount the enclosure to the Rigging Frame, as shown in the assembly diagrams.
Fix a supplied Joint Plate securely to the left side of the Rigging Frame and another to the right side of the
enclosure, each using 4 supplied bolts with plain washers and spring washers.
Before securing the Joint Plate, determine whether the enclosure’s horn will face right or left. (This is not
required for the SR-A18B Subwoofer.) When suspending the subwoofer, install the system so that the
subwoofer is positioned at the top (directly below the Rigging Frame).
Joint plate
Flying plate
Joint plate
Joint plate
Joint plate
Flying plate
High box assembly diagram
Join the enclosure to the Rigging Frame securely, using 4 supplied bolts with plain washers and spring
washers on each side. For Joint Plate mounting holes, use the hole that creates an overlapping angle of 0
degree. Refer to the assembly diagrams below.
(Right side) (Left side)
Subwoofer assembly diagram
(Left side) (Right side)
High box finished assembly diagram
Subwoofer finished assembly diagram