Toa HY-MT7 - Manual (Page 3)

Step 3. Mount the MT-200 to this adapter.
Mount the MT-200 as shown in the figure at
right. Its completed installation is shown in the
“MT-200 Mounting Example” figure on the front
page.
Tip
Be sure to keep the MT-200’s cover removed.
Note
When installing speaker systems under eaves,
be sure to install in a vertical array. Further, to
ensure the MT-200’s waterproofing capability,
install it so that its top panel surface is tilted
within 45º of the vertical plane.
If the MT-200’s waterproofing capabilities
cannot be ensured by the mounting method
shown in the figure at upper right, mount the
MT-200 as shown at lower right.
Refer to the operating instructions supplied with
the MT-200.
MT-200 (without cover)
This adapter
Tightening torque:
8 N·m
Hex head bolt (supplied
with the MT-200)
Plain washer for M8
(accessory)
Nut for M8
(accessory)
Step 4. Mount this adapter to the rear panel of the speaker module.
This adapter can be attached to any
speaker module, however there may be
cases in which they cannot be easily
attached due to their combination with
other optional mounting brackets. In such
cases, attach this adapter to any free
speaker module.
This adapter
Hex head bolt M6 x 16
(with spring and plain
washers, accessory)
Tightening
torque: 3 N ·m
MT-200
45° 45°
UP
Top surface
MT-200 (without cover)
Tightening torque:
8 N·m
Hex head bolt (supplied
with the MT-200)
This adapter
Plain washer for M8
(accessory)
Nut for M8
(accessory)