Toa H-3WP - Manual (Page 7)

7
Step 2. Wiring and impedance settings
Step 2-1. Unplug the detachable input connector from
the speaker socket, and loosen the screws
of the terminal with a screwdriver.
Detachable input connector
Step 2-2. Insert the stripped cable ends into the input connector, and retighten the terminal screws.
[Single connection] [Bridge connection]
From power amplifier
To next speaker
Note
When not bridging the connection, tighten the screws of unused terminals to prevent resonance
noise.
Step 2-3. Attach two sockets to the impedance selection connector to select the desired impedance.
The impedance is preset to 330 Ω (30 W for 100 V line and 15 W for 70 V line).
[When selecting 8 Ω] [When selecting 16 Ω] [When selecting 330 Ω]
(Preset by the factory)
Socket
Note
The H-3 and H-3WP speakers are designed to be used for both 70 V and 100 V line applications.
When using the 100 V line, do not select the "170 Ω" impedance, since the speaker itself or power
amplifier may be damaged.