Toa H-3WP - Manual (Page 10)

10
7. OUTDOOR USE (H-3WP ONLY)
7.1. Installation Precautions
• The H-3WP features drip-proof construction for permanent outdoor installation. However, do not dash water
over it when cleaning as this may cause damage to the speaker components.
• When installing the H-3WP in a snowy area, protect the speaker so that it is not covered with snow.
7.2. Waterproofing the Base Frame
The H-3WP's base frame has a gasket for watertightness. To
prevent water from getting into a gap between the base frame
and wall, apply commercial caulking agent over the inside of
the gasket before mounting the base frame.
Note
Take care not to apply too much caulking agent. If it spreads
to the lock tab, the lock tab does not smoothly rotate and the
speaker may not be mounted or detached.
Caulking agent
Gasket
Base frame
8. REPAINTING THE FRONT GRILLE
Follow the procedures below to change the color of the grille:
Step 1. Wipe dirt off the front grille with a soft cloth moistened with a detergent before painting. Do not use
volatile liquids such as thinner.
Step 2. Uniformly spray a thin coating of paint over the grille changing the spraying positions gradually.
Notes
• Do not use a roller or brush to paint because the grille mesh could be clogged with paint.
• Use paint that is appropriate for the material of the front grille (grille and frame).
[H-3] Grille: Rolled steel plate
Frame: Fire-resistant ABS resin
[H-3WP] Grille: Rolled steel plate (zinc plating)
Frame: Fire-resistant ABS resin
• Follow the instructions on the paint when painting.
Step 3. After the paint dries, repeat Step 2 to repaint.
Note
Be sure to repeat Step 2 at least twice. If you paint only once, the paint may not be uniformly applied
or the grille mesh may be clogged.