Toa IR-802T - Manual (Page 10)

10
Step 1. Turn on the unit’s power switch.
The power indicator lights.
Step 2. Turn on the infrared wireless microphone’s power switch.
The reception indicator lights for the channel receiving a signal.
Step 3. Adjust the volume control knob for an appropriate output sound.
Note
Output signal distortion is more likely to increase when the volume control knob is set beyond the “7”
position.
Step 4. Adjust the equalizer controls for an appropriate sound quality.
Each of low-, middle-, and high-frequency outputs can be individually adjusted.
Notes
• Sound quality of the infrared wireless microphones and each audio signal input to the AUX terminals
cannot be individually adjusted.
• Acoustic feedback tends to occur when the MID level is set relatively high.
IR-200M
Infrared Wireless Microphone
IR-300M
Infrared Wireless Microphone
IR-802T
Rear
1
3
4
2
2
8.1.2. Sound quality adjustment
Adjust the sound quality when installing the IR-802T.
The example here shows the procedure to adjust the sound quality of the IR-802T using the infrared wireless
microphone.
Lights