Toa IR-702T - Manual (Page 14)

14
11.1. Wall Mounting
11. INSTALLING THE IR-500R INFRARED WIRELESS RECEIVER
Chassis
BNC jack cable
To BNC connector
1
2
-1
Case fixing screws
Body case
Step 1. Loosen 2 case fixing screws, then detach
the body case with screws.
Note
No need to remove these case fixing
screws.
Step 2. Connect the coaxial cable.
2-1. When using the BNC connector
Connect the BNC cable to the BNC jack
cable connected to the chassis.
Note
Applicable coaxial cable is RG-59/U or
RG-6/U.
2-2. When connecting the coaxial cable directly
(1) Loosen 2 coaxial cable fixing screws
on the chassis, then disconnect the
BNC jack cable.
Strip the jacket 13 mm (0.51")
from the end of the coaxial cable. Strip the dielectric 10 mm
(0.39") from the cable end. Unravel the braided shield
and turn it back.
Braided shield Dielectric
10 mm
(0.39")
13 mm
(0.51")
Dielectric Conductor
(2) Treat the coaxial cable end.
(3) Insert the end-treated cable, then securely tighten the coaxial cable fixing screws.
Chassis (rear)
Coaxial cable fixing screws
End-treated
coaxial cable
BNC jack cable
(1)
(3)