Toa NX-100S Installation - Manual (Page 90)

5-2
Chapter 5: OPERATION SETTINGS (NX-100 OPERATION PROGRAM)
1. NX-100 OPERATION PROGRAM SUMMARY
This operation program is used to set the control buttons used for broadcasts, and activate set NX-100 and
NX-100S broadcast patterns*
1 or operate the contact output* 2 .
* 1 The broadcast pattern is determined by the combination of the contents of the sound source and the units
targeted to receive the broadcast. One target unit can be set for unicast streaming, and up to 64 units for
multicast streaming. Only one pattern can be set per button.
Note
For more information concerning broadcast pattern settings, refer to
Chapters 3 and 4 .
* 2 The NX-100's and NX-100S' contact output is controlled via the network. Up to 64 units x 8 channels can
be controlled per button.
2. STARTUP AND INITIAL SCREEN
Either double-click on the Operation program icon created on the desktop at the time of program installation or
double-click on the application [nx100_control.jar] installed in the software folder. The following initial window
(with nothing set in it) will then be displayed.
Group buttons Selection buttons
The 10 Group buttons and 50 Selection buttons are displayed, with each button being numbered before any
button setting is performed.