Toa NX-100S Installation - Manual (Page 26)

2-15
Chapter 2: UNIT AND SOFTWARE INSTALLATIONS
5.4.3. Installation folder configuration
The NX-100 software is saved by default in C:\Program Files\TOA\NX-100.
Shown below is the NX-100 folder (Installation folder) configuration.
(Installation folder)
jh.jar
nx100_control.jar (Operation Program)
nx100_util.jar (Setup Program – Installation Setting)
nx_help.jar
packetaudio.jar
NX-100
Data in the data folder are commonly used by both the Setup Program and the Operation Program. The Setup
Program and the Operation Program always operate based on the unit setting files in the data folder.
Manually opening or saving these files cannot be performed.
Do not change the configuration or name of the file or folder in the installation folder.
When creating other systems or saving backup copies, copy the data folder into other location and save it. (To
reuse, replace the data folder with the one in use.)
5.5. Uninstalling Each Software
Select [Control Panel] → [Add/Remove Programs] to delete.
(Data folder)
Config (folder to store unit setting files) [IP address].cfg (unit setting file)
Log (folder to store logs)
panel.nxc (operation program system file)
system.nxc (setup program system file)
[IP address].log (unit operation log file)
NX-100
The system setting files are saved by default in the following locations.
• In the case of Windows 2000/XP
C:\Documents and Settings\All Users\Application Data\TOA\NX-100
• In the case of Windows Vista/7
C:\ProgramData\TOA\NX-100
Shown below is the NX-100 folder (Data folder) configuration. The Unit setting files and Setup program
system file are created after setting completion on the Setup program, the Operation program system file after
setting completion on the Operation program, and the Unit operation log file at the log file download on the
Setup program.