ThermoWorks 292-701 SAF-T-LOG PAPERLESS HACCP THERMOMETER Operating Instructions - Manual (Page 4)

4
Saf-T-Log Basics
Auto-Off
Auto-power off will occur 10 minutes after the last button press to conserve battery life This may be disabled
by entering the Instrument Menu The Instrument Menu is entered by simultaneously pressing the Up () and
Down () buttons and scrolling to the option “Change Auto-Off” Press ‘Rec’ button to enter the function,
scroll to the desired option “AutoOff ENABLED” or “AutoOff DISABLED” and pressing ‘Rec’ button to select
The Saf-T-Log will store this setting until changed by a user
Battery Indicator
The battery indicator is located at the upper right corner of the instrument display When the icon shows
almost empty it is recommended to change the batteries See page 18 of this manual for instructions on
changing the batteries When the Saf-T-Log instrument is connected to the PC and the desktop software is
open, the software will prompt the user to change the batteries if the battery power is low
Selecting a Checklist
The Saf-T-Log is capable of storing up to 7 checklists on the device at a time One checklist is active at a
time and can be switched for another one on the device To view the current checklist, cycle the power and
on startup the name of the checklist that is active will be displayed Alternatively, the active checklist can be
viewed in the Instrument Menu by simultaneously pressing the Up and Down buttons, scrolling to the ‘Change
Checklist’ menu and pressing the Record button The active checklist will be displayed first To change to
another checklist scroll to the desired checklist and press the Record button Press record again to exit the
menu
User List
The current user may be changed on the Saf-T-Log device without reconnecting to the PC The ‘User’ list for
the current checklist stored on the Saf-T-Log is accessed by pressing the ‘Up’ () and ‘Down’ () buttons
simultaneously to enter the Instrument Menu Scroll to the option “Change User” and press the ‘Rec’ button
to view the list of users that were setup in the Checklist stored on the Saf-T-Log device Scroll to the desired
user to select and press the ‘Rec’ button to store the entry and exit the Instrument Menu The new user is now
active Alternatively, to display the current user selected on the Saf-T-Log device, press and hold the ‘ON /
OFF’ (Backlight) button for 3 seconds at startup Note: When changing checklists on the handheld device, it is
important to know that the user list will also change with the active checklist. It is recommended to check the
current user when changing to a different checklist.
Temperature Unit Display
The temperature unit display (°F or °C) can be changed by use of the Saf-T-Log software The device will
display temperature in the scale that the Checklist was set to display in See section entitled ‘Changing Saf-T-
Log Temperature Units (°F or °C)’ for complete instructions (page 9) Note: When using multiple checklists,
the first checklist being loaded will set the default temperature scale for the rest of the checklists.