ThermoWorks 292-701 SAF-T-LOG PAPERLESS HACCP THERMOMETER Operating Instructions - Manual (Page 14)

14
Software
Once the appropriate Checklist has been stored onto the Saf-T-Log device, readings can be stored Connect a
suitable type K temperature probe to the Saf-T-Log device noting the correct polarity (+ or – ) Power the unit
on Using the ‘Up’ () and ‘Down’ () buttons, scroll to the desired item to be measured For temperature
items insert the tip of the probe into the desired medium and select ‘REC’ to store
the reading For Yes/No questions, select ‘REC’ to view the Yes or No choice,
scroll to the desired selection and press ‘REC’ again If the stored reading falls
outside of the item’s hi/lo limits, a corrective action may be selected by the user
if the checklist was setup to include corrective actions ‘Recorded # xx’ will
then flash momentarily on the display to confirm that the reading was stored For
temperature items, note that a PASS or FAIL will be displayed in the upper display
based on the HI: and LO: settings of the item selected Up to 1,000 readings can be stored on the Saf-T-Log
device Once the maximum limit has been reached, a message will be displayed ‘Memory Full’ indicating
that the reading memory is full and should be downloaded No other readings will be possible until the sync
process is completed
Recording Temperatures and Yes/No Questions
NOTE: It is recommended to check that the appropriate user is selected before using the Saf-T-Log device or
when changing the active checklist on the unit. This is done within the Instrument Menu by pressing the ‘Up’
() and ‘Down’ () buttons simultaneously, scrolling to ‘Change User,’ and then pressing the ‘Up’ () and
‘Down’ () buttons to scroll to the appropriate user, and then pressing ‘REC’ to select.