ThermoWorks P770 PRINTING DATALOGGER THERMOMETER - Manual (Page 12)

Push [ENTER/MENUE] and use the up and down
keys [
ᮡᮢ ] to select ArEA. Push [ENTER/MENUE]
to confirm. On the left corner of the display appears
a small 1, which indicates the selected channel. For
changing the channel use the up and down keys
[
ᮡᮢ ] . Push [ENTER/MENUE] to confirm. Use the
up and down keys [ ᮡᮢ ] to select the dimension
unit:
c = Centimeter 2
m = Meter 2
Push [ENTER/MENUE] to confirm.
On the display bottom appears:
00.00
For changing the number use the up key [ ᮡ ] . For
stepping to the next number use the key down [ ᮢ ].
If the requested dimension is complete then push
[ENTER/MENUE] to confirm.
1.4.7 Memory Setup [Lo6]
Only instrument with extension –LOG (e.g. P755-
LOG) have got an internal memory.
Push [ENTER/MENUE] and use the up and down
keys [
ᮡᮢ ] to select Lo6. Push [ENTER/MENUE] to
confirm. Use the up and down keys [ ᮡᮢ ] again to
start [on] or Stop [off] the logger. Push [ENTER/
MENUE] to confirm. Use the up and down keys
[
ᮡᮢ ] again to select between automatic storage
[Auto] or manually operated storage [SPot]. Push
[ENTER/MENUE] to confirm]. Use the up and down
keys [
ᮡᮢ ] again to select between to add on data
[Add] and creating a new file [nLo6]. Push [ENTER/
MENUE] to confirm. By selected automatic storage
at the end you have to select the time interval:
1 S 1 second
5 S 5 seconds
10 S 10 seconds
20 S 20 seconds
30 S 30 seconds
1 M 1 minute
2 M 2 minutes
5 M 5 minutes
10 M 10 minutes
20 M 20 minutes
By selected manually operated storage you are able
to save the measurement by pressing ESC by each
time.
Push [ENTER/MENUE] to confirm. Push [ESC] to be
back in the measuring mode. Manual storing [Spot].
Press the key [ESC] to store manually the measuring
values.
12
Unit
ᮣ ᮣ
ᮤ ᮤ
MENUE
Prob Lin2 CAL PrEn Chnl ArEA Lo6
DE P700 Anleitung engl. 08/10 27.08.2010 14:02 Uhr Seite 12