TeeJet FieldPilot Install Case IH 2x90, 2x94, 3x94 - Manual (Page 22)

www.teejet.com
20
FieldPilot ®
14. installation oF engage/disengage switch
Connect item (A) to the connector on the SCM harness labeled Remote Engage/Disengage. Install the push
button in a location that is easily accessible during operation of the machine. This switch (A) is not required
if the optional foot switch 32-04020 is used.
Figure 1-16: Engage/Disengage Switch
15. recoMMended electronics installation
The Steering Control Module (SCM) should be mounted securely to the floor of the cab as far forward in the
cab as possible.
NOTE: There are wires under the floor mat so be sure that the SCM mounting does not damage them.
The control console can be mounted to the operator’s preference. The GPS antenna should be mounted
near the nose of the vehicle on a metal surface of at least 4” square.
Figure 1-17: Recommended Electronics Installation
sCM
Console
Gps