Fieldpilot, Existing hole sensor bracket – TeeJet FieldPilot Install Case IH 2x90, 2x94, 3x94 User Manual
Page 21
www.teejet.com
19
FieldPilot
®
13. install steering disengage switch (kit 91-07011)
The steering disengage kit
(EE)
is used to automatically disengage FieldPilot when the steering wheel is
turned. The magnets mount on the steering shaft or other rotating part of the steering wheel and the sensor
mounts so that there is a 1/8” clearance between the sensor and magnet.
Remove any shields around the steering shaft in the cab. Locate the existing hole as shown. Use one (1)
of
(B)
, one (1) of
(D)
, and one (1) of
(E)
to mount the bracket from kit
(EE)
. The magnets will need to be
cut in half. Three (3) should be attached to the steering shaft. Install the sensor from kit
(EE)
and set its
clearance at 1/8 inch from the magnets.
Figure 1-15: Install Steering Disengage Switch (Kit 91-07011)
existing hole
sensor
Bracket