TeeJet FieldPilot Install Case 71x0-72x0-89x0 - Manual (Page 18)

16
www.teejet.com
FieldPilot ®
11. install steering engage/disengage sWitch
Connect item (W) to the connector on the SCM harness labeled Remote Engage/Disengage. Install the push
button switch in a location that is easily accessible during operation of the machine. Optional foot switch 32-04020
can be used in place of switch (W) if desired.
Figure 1-16: Install Steering Engage/Disengage Switch
12. install ValVe control caBle
Route the valve control cable (R) from the FieldPilot valve toward the rear and under the cab. Connect the DIN
connectors to the valves as illustrated. Secure the valve cable with tie-straps as required. Remove the left hand
lower door seal plate to allow for cable routing. Bring the cable up from under the cab and through the door seal.
Lift the floor mat and route the cable toward the front right corner of the cab. Lay the floor mat back down over the
cable and reinstall the lower door seal plate.
Figure 1-17: Installing the Valve Control Cable
R