New ab? mark a mark b – TeeJet CenterLine v1.07 User Manual
Page 40
34
CenterLine
CenterLine Real-Time Operation
CenterLine
Software Version 1.07
Marking A and B Locations
The Straight-line and Curve AB guidance modes require a reference guideline to guide the vehicle
along. Establishing a guideline involves marking two points along the reference guideline. To
establish this reference guideline using the real-time menu, use Up or Down to scroll in the menu
until
is displayed. Mark the A location by pressing Enter when the desired location is
passed. The menu item is now displayed. To mark the B location, press Enter when
the desired location is passed. The reference guideline is now established and the lightbar dis-
plays guidance information. See the underlined caution under “Curve AB Guidance Operation” on
page 45, when establishing AB guideline for Curve AB operation.
Switching between Guidance Modes
There may be situations where it is necessary to switch between guidance modes. Typically an
operator makes one or more passes around the field’s headland area in the Headland guidance
mode. While driving the headlands, the operator may mark the A and B guideline points to be used
when switching modes. When the headlands are completed, the operator switches to the Straight-
line or Curve AB mode, and completes the field in a back and forth fashion.
To switch between guidance modes, scroll the real-time menu (See Figure 32 on page 32) until
press Enter to make it active.
Figure 33: The Mark A Mark B Sequence
NEW AB?
MARK A
MARK B