TeeJet SENTRY 6510 - Manual (Page 13)

11
990-630-EN R0
Sentry 6510 Capacity Monitor
OPERATION
User interface
Figure 17: User interface buttons
The LEDs on each bar graph indicate the current relative loss value as measured by the straw walker sensor and the sieve sensor.
When the monitor is turned on, the bottom LED in each graph will be on, indicating the power is on and the system is running as expected.
Press the + and - buttons to change the sensor gain, which in turn alters the reading on one of the graphs up or down by one light. Hold the
button to continue raising or lowering the gain.
Press + and - simultaneously to set the reading to the middle (50%).
These cases will prevent changing gains:
• If no loss is detected at all, the reading cannot be changed at all
• If the reading is above ten, the reading cannot be increased
• If the reading is below one, the reading cannot be decreased
• If the loss is very low, it may not be increased to the maximum, but will be adjustable to the highest possible value
NOTE: To ensure that the grain loss readings are as accurate as possible, it is recommended to check the reading of the monitor against
actual grain loss frequently, as described in Calculation of grain loss .
Sieve loss
bar graph
Straw walker
loss bar graph
Press to increase
reading
Press to decrease
reading
Press both to set
reading to 50%