TeeJet SENTRY 6510 - Manual (Page 12)

10
www.teejet.com
Sentry 6510 Capacity Monitor
Figure 14: Bung and spacer placement
7. Tighten the nuts so that the rubber swells slightly.
NOTE: The bolts in the bung must not touch the plastic spacer.
Connecting the sieve sensor cables
1. Connect the plug to the sensor.
2. Fasten the cable to the bracket using a cable fastener.
Figure 15: First sieve sensor cable fastener
3. Make a bend in the cable large enough to “capture” the movement of the sieves.
4. Fit another cable fastener to the side of the machine.
Figure 16: Second sieve sensor cable fastener
5. Connect the cable to the junction box, avoiding any sharp edges, pinch points or other sources of cable damage, and fasten to the
combine harvester using supplied cable ties.
6. Connect the cables to the circuit board as shown in Figure 2.
5 mm