TC-Helicon VoiceLive Touch 2 Reference Manual - Manual (Page 38)

The Slider FX
32
Chapter Overview
In Effects and Loop modes, the Slider FX Bar can be used to
activate and modulate an effect. The selection of effects is dif-
ferent when in the Effects menu from when you’re in the Loop
menu. The name of the effect is shown at the bottom of the
display. Slide your finger over the Slider FX bar, drag and stop
or tap to use the effect.
Using and assigning the Slider FX is described in the “Slider FX
Bar effects” section of the VoiceLive Touch 2 Quick Guide.
Following are descriptions of each effect that can be assigned to
the Slider FX bar in the Effects menu.
Gender Warp effect
Tap the Slider FX Bar to activate the Hardtune effect at its
current settings.
Slide your finger over the Slider FX Bar to sweep the lead voice
Gender setting from more male at the left to more female at
the right.
Delay Feedback effect
Tap the Slider FX Bar to activate the Delay effect at its current
settings .
Slide your finger over the Slider FX Bar to change the Feedback,
which extends or shortens the length of the echo effect.
Harmony Hold effect
Tap the Slider FX Bar to activate the Harmony effect and apply
Harmony Hold which produces infinite sustain of the harmony
voices as long as you hold your finger on the Slider bar.
Slide your finger over the Slider FX Bar to control the volume
of the held harmony notes.
Dual Filter effect
Tap the Slider FX Bar to activate the Transducer effect at its
current settings.
Slide your finger over the Slider FX Bar to sweep the Low Cut
and High Cut settings.
Harmony Bend effect
Tap the Slider FX Bar to activate the Harmony effect at its
current settings.
Slide your finger over the Slider FX Bar to sweep the pitch of
the Harmony voices.