TC-Helicon Voicesolo FX150 - Reference Manual User Manual
Page 37

Advanced controls
VoiceSolo FX150 Reference manual 35
Input 1 trim
We have pre-set the input trim on Input 1 such
that you shouldn’t need to adjust it.
If you do need to make a change, you may do so
ONLY in CH1 mode.
Press and HOLD the LEVEL button on the input
you’d like to change.
Use the Edit knob to increase or decrease the
gain.
Press the LEVEL button again to confirm your
changes and exit.
Input 1 metering
We offer visual input metering for Channel 1,
when CH1 is the output mode.
To activate the input meter, press and hold
Channel 1’s LEVEL button for a few seconds.
The buttons will light up to show how much in-
put signal is coming into Channel 1. The lights
will “bounce” up and down as the level changes.
Ideally, you want to see the Vocal Tone button
lighting up yellow when you are singing/playing
at your loudest. If the Vocal Tone button turns
red, the input is overloading, and you should turn
the level down slightly, following the Input Trim
instructions above.
Mic control
The FX150 takes advantage of Mic Control en-
abled microphones to activate/deactivate the
Reverb effect. This is extremely useful if you’d
like to talk to your audience without Reverb. Mic
Control allows you to quickly turn Reverb on and
off.
First, make sure the +48V (Phantom Power)
switch is pressed IN on the back of the FX150
unit. Mic Control can’t work without Phantom
Power.
To enable Mic Control on Channel 1 or Chan-
nel 2, press and hold the Reverb Level button
for five seconds. You will need to perform this
procedure on each channel that you’d like Mic
Control active on.
When Mic Control activates, you will see the Lev-
el button blink a few times.
To disable Mic Control, repeat the above pro-
cess for each channel. The button will blink again
to verify that Mic Control has been turned off.
Factory reset
If you wish to restore your FX150 to its factory
settings, press and hold all three LOW buttons
(in the EQ section) while powering on the unit.
Continue holding the buttons until the unit has
fully powered up.