Monitor mix, Hi z full mix, Master edit – TC-Helicon Voicesolo FX150 - Reference Manual User Manual
Page 34: Inputs 1+2

Controls – aka “Pushing buttons”
VoiceSolo FX150 Reference manual 32
There are two knobs on the FX150:
1. The Edit knob controls parameters depending
on selection.
The Edit knob has a semi-circle of LED’s sur-
rounding it. From left to right, these LED’s rep-
resent minimum to maximum values for each
parameter. LED’s may light one at a time or in
groups, depending on how many options are
available.
2. The Master knob controls the speaker volume.
The Master knob does NOT change the volume
of the OUT connection.
Each channel has several controls. The controls
for input 1 and input 2 are identical, so we will
just describe them once.
To adjust any of the parameters listed below,
push the button for the parameter that you’d like
to change: Level, High, Mid, Low, Style etc.
Use the Edit knob to make changes.
Press the button again to exit and save your
changes.
Inputs 1+2
+
+
+
=
Monitor Mix
+ Aux
1
2
Aux
EQ
REVERB
Edit
VOICESOLO FX-300
Master
Level
Level
Level
High
Mid
Low
High
Mid
Low
High
Mid
Low
Level
Style
Level
Voice
Cancel
Vocal
Tone
Vocal
Tone
HI Z
FULL MIX
Master
Edit
– Press the “Level” button and use the Edit
knob to control the volume of the associated
channel.
If the Vocal Tone button lights red at any time
during your performance, the Input is clipping
and the level should be reduced.
– Press the “Vocal Tone” button to switch the
Voice Tone section of the associated chan-
nel on or off. The Voice Tone section includes
an adaptive EQ, compression, de-essing and
gating.
Using Vocal Tone is highly recommended for
microphone inputs.