Usb connector – TC-Helicon Voicesolo FX150 - Reference Manual User Manual
Page 15
Connecting – aka “Exploring the ins and outs”
VoiceSolo FX150 Reference manual 13
Out
This XLR output can operate in two ways, de-
pending on whether you are using Input 2 as
a “normal” input for guitar/vocals etc. or for a
monitor mix coming from the Front-of-House
(FOH) mixer.
First we will cover FULL MIX:
When using Inputs 1 & 2 for guitar/vocals etc.,
the OUT will send “what you hear” coming from
the FX150’s speaker to a PA or mixer. This output
also contains sounds from the AUX input.
This is the most likely way a solo performer will
use the FX150, especially in a smaller venue.
Next, we will cover CH1 mode:
FX150
A. When you have pressed the FULL MIX/CH1
switch, the OUT will send only the sounds
from Input 1.
B. The combination of Input 1, Input 2 (Monitor
Mix) and Aux is what you will hear from the
FX150’s speaker.
C. You will only hear Input 1 coming from the P.A.
When looking at the diagram above, keep the
“Diagrams” (page 6) section in mind. Grey
lines represent cables and the images in the
bottom boxes show “What you hear” from your
FX150 and from the P.A.
The P.A. images only show signals that “belong”
to you. We don’t show the rest of the band.
USB connector
The USB connector on the FX150 allows for up-
dates of the unit’s firmware (if and when such an
update is released).
Updating firmware is done via our VoiceSupport
program. You can download VoiceSupport at
The USB connector does
not
pass audio.