SUUNTO Vyper Air - Manual (Page 98)

9.2. Required tools
•
A flat 1.5 mm screwdriver or a special tool for spring bars (K5857).
• Soft cloth for cleaning.
• Needlenose pliers or small screwdriver for turning securing ring.
9.3. Replacing the battery
The battery and the buzzer are located in the back of the instrument in a separate
compartment. To change the battery:
1.
Remove the computer from the console or boot.
Wrist model:
•
Pull off the boot. Remove it first from the front end with the longer part of the
strap.
• Disassemble the shorter part of the strap with a flat 1.5 mm screwdriver or a
special tool for spring bars. The longer part of the strap may stay on but re-
moving it may ease the work later on.
Console model:
•
Remove the dive computer from the console according the instructions of the
console.
2. Thoroughly rinse and dry the computer.
3. Open the securing ring of the battery compartment lid by pushing it down and
rotating it clockwise. You may use a pointed nose pliers or a small screwdriver
as an aid in the rotating. Put the pliers ends into the holes of the securing ring or
the screwdriver onto the side of the right tooth on the ring and turn the ring
clockwise. Be careful not to damage any of the parts.
4. Remove the ring.
98