SUUNTO Vyper Air - Manual (Page 100)

16. Turn the locking ring counterclockwise with your free thumb and fingers until it
snaps into its locked position.
17. The dive computer should now active its timekeeping mode and show time 18:00
[6:00 PM] and date SA 01,01. Activate the instrument. Check that
•
all display segments work.
• the low battery warning is off.
• the buzzer beeps and backlight works.
• all the settings are correct. Reset if necessary.
18. Install the dive computer back into the console or boot and reassemble the strap.
The instrument is now ready for use.
Wrist model:
•
Assembling into the boot: First insert the longer strap in its hole in the front of
the boot and then the dive computer into its cavity in the boot starting at the
back end. Then snap also the long strap end of the instrument into the boot.
Stretch the boot as needed.
• Assemble the shorter part of the strap. Use the spring bar tool or small
screwdriver to compress the spring bars. Make sure that the spring bars get
fully seated so they will not come off their holes.
Console model
•
Refit the dive computer in the console according the instructions of the console.
CAUTION
Check after the first dives for possible moisture under the trans-
parent battery compartment lid, indicating a leak.
100