SUUNTO Vyper Air - Manual (Page 40)

When the dive computer is in the permanent Error mode, only the Er warning is shown
in the center window. The dive computer does not show times for ascent or stops.
However, all the other displays function as before to provide information for ascent.
You must immediately ascend to a depth of 3 to 6 m/10 to 20 ft and remain at this
depth until air supply limitations require you to surface.
After surfacing, you should not dive for a minimum of 48 hours. During the permanent
Error mode, the Er text is displayed in the center window and the planning mode is
disabled.
5.6. Wireless transmission
The Vyper Air can be used together with an optional wireless cylinder pressure
transmitter that easily attaches to the high-pressure port of the regulator. By using the
transmitter, you can benefit from receiving cylinder pressure and remaining air time
data direct to your wrist.
In order to use the transmitter, the wireless integration needs to be enabled in your
Suunto Vyper Air's settings. To enable or disable the wireless integration, refer to
Section 5.7.10. Setting the tank pressure.
5.6.1. Installing the wireless transmitter
When purchasing the Suunto Vyper Air, we strongly recommend that you have your
Suunto representative attach the transmitter to the first stage of your regulator.
However, if you decide to attach it yourself, do the following:
1.
Remove the high pressure (HP) port plug on the first stage of your regulator using
an appropriate tool.
40