2 installing scratch guard, 3 changing strap to bungee – SUUNTO EON STEEL User Manual

Page 56

TIP: Remember to register your Suunto EON Steel at

www.suunto.com/support to get personalized support.

4.2 Installing scratch guard

Use the provided scratch guard to help protect your Suunto EON
Steel from scratches.
To install the scratch guard:
1. Ensure the display glass is clean and dry.
2. Peel back the protective layer from one end of the scratch

guard.

3. Place exposed adhesive side down squarely on one end of the

display.

4. Pull back the protective layer from the scratch guard.
5. Press out any air bubbles with a soft, straight edge tool.

4.3 Changing strap to bungee

You can change between the wrist strap and bungee as needed.
The bungee is provided as an option.
To install the bungee:
1. Remove both strap ends using a TORX T7 (non-IP) screwdriver.
2. Attach the bungee adapters.
3. Thread the cord through both adapters.
4. Securely tie the ends of the bungee cord and cut off excess cord.