SUUNTO EON STEEL - Manual (Page 36)

NOTE: It is always recommended to keep close to the
decompression ceiling when ascending.
Ascent time is always the minimum time needed to reach the
surface. It includes:
• Time required to do deepstops
• Ascent time from depth at 10 m (32.8 ft) per minute
• Time needed for decompression
• Time needed for extra safety stops if ascending too fast during
the dive
WARNING: Your actual ascent time may be longer than
displayed by Suunto EON Steel . It may be longer if your ascending
speed is slower than 10 m (32.8 ft) per minute or you are doing a
decompression stop deeper than the recommended ceiling. Take
this into account, since it might increase the amount of required
breathing gas to reach the surface.
3.11 Display brightness
The brightness of the display can be adjusted under General /
Device settings / Brightness. The default value is 50%.
3.12 Dive history
Dive history is a summary of all the dives done with your Suunto
EON Steel . The history is divided by the type of dive: Air, Nitrox,
Trimix and Gauge dives are logged separately. Each type summary
36