SUUNTO EON STEEL - Manual (Page 55)

4 CARE AND SUPPORT
4.1 Handling guidelines
Handle Suunto EON Steel with care. The sensitive internal electronic
components may be damaged if the device is dropped or otherwise
mishandled.
Do not try to open or repair Suunto EON Steel by yourself. If you
are experiencing problems with the device, please contact your
nearest authorized Suunto Service Center.
Wash and dry the dive computer after use. Rinse very carefully after
any salt-water dive.
Pay special attention to the pressure sensor area, water contacts,
pushers, and USB cable port. If you use the USB cable before
washing the dive computer, the cable (device end) should be rinsed
as well.
After use, rinse it with fresh water, mild soap, and carefully clean
the housing with a moist soft cloth or chamois.
NOTE: Do not leave your Suunto EON Steel in a bucket of water
(for rinsing). The display stays on under water and consumes battery
life.
Use only original Suunto accessories - damage caused by non-
original accessories is not covered by warranty.
55