StarTech.com SATDUP11IMG Manual - Manual (Page 5)

Instruction Manual
2
Introduction
Packaging Contents
• 1 x HDD Duplicator/Eraser
• 2 x 10cm SATA Cables
• 2 x 50cm SATA Cables
• 1 x eSATA + 5V DC Type F Power Cable
• 1 x eSATA + 12V DC Type M Power Cable
• 1 x Power Adapter
• 3 x Power Cords (NA, UK, EU)
• 2 x HDD Pads
• 1 x Instruction Manual
WARNING! Hard drives and storage enclosures require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and storage device with caution. Be sure that
you are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
Hardware Installation
WARNING! Hard drives and drive duplicators require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and duplicator device with caution. Be sure that
you are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
1. Ensure the power switch is set in the off position. Using the included Universal
Power Adapter, connect the Power Adapter Port on the back of the
SATDUP11IMG to an available power outlet.