Sportline Hydracoach - Manual (Page 25)

…
h
Proper Care and Cleaning
The HydraCoach disassembles into seven main components.
(See Disassembling and Reassembling the HydraCoach) This
allows you to clean the system easily and thoroughly. The best
methods for cleaning the individual components are as follows:
Bottle – The Bottle is made of BPA–Free material. It
should be washed by hand in warm soapy water. It may then
be wiped dry with a soft cloth or left to air dry. DO NOT
place the bottle or the electronic module in the dishwasher.
Computer – The Computer may be polished with a soft
cloth in most cases. However, a slightly damp cloth may be
used if necessary. Note: Be careful not to scratch the lens
area. Never use solvents, abrasives, or harsh chemicals
or materials to clean the Computer. Never submerge the
Computer in water or other liquid medium. DO NOT place
in the dishwasher.
Impeller Assembly and Tubing – To thoroughly clean the
Impeller Assembly and Tubing, they should fi rst be soaked in
warm soapy water, making sure that no air is trapped within
the components. Next, fl ush the system with a stream of
warm running water through the bottom end, or the end that
the longer Draw Tube attaches. Once fl ushed thoroughly,
it is now ready for use. To dry, the Tubing should be
disconnected from the Impeller Assembly, air blown through
the components to rid the system of excess water, and then
left to air dry.
Mouthpiece, Upper Cap and Bezel – These components
are best washed by hand in warm soapy water and then
rinsed clean. However, they may be placed in a dishwasher’s
upper rack and away from heating elements if absolutely
necessary. They may then be wiped dry with a soft cloth or
left to air dry.
When not in use, the HydraCoach should be allowed to dry
completely and then stored away for safe keeping until you
want to use it again.
25
SP3906IS0ISPORE.indd 25 3906IS0ISPORE.indd 25 10/20/08 4:38:07 PM 10/20/08 4:38:07 P