Solvline CS-CAN Command Manual - Manual (Page 9)

9
Configuration commands
2.3 Configuration commands
Command --
Description - Exit from Configuration mode
- Return Syntax: OK
Example When -- is received in Configuration mode, OK is returned and it will
operate in Active mode.
Command &F
Description - Change all settings to the default settings in CAN converter.
- Settings are applied after the reset is completed.
- Return Syntax: OK
Example When CS-CAN takes &F command, configurations for CAN and RS232
will be reverted to factory default configuration. (Factory default - CAN: 125kbps,
RS232: 9600bps, 8N1)
Command WC(BS)
Description - A command to set the communication environment in CAN.
- B  Baud rate
0: 83kbps 1: 100kbps 2: 125kbps
3: 250kbps 4: 500kbps 5: 1000kbps
- S  CAN Spec.
A: CAN 2.0 A B: CAN 2.0 B
Example When CS-CAN takes WC2B command, it will set the CAN Baud rate to
125Kbps and Spec. to CAN 2.0 B.