Solvline CS-CAN Command Manual - Manual (Page 11)

11
Configuration commands
Command CE(eE)
Description - The command for transmitting extended CAN frame can be changed.
- If you change to the command that already exists, CS-CAN may not operate
properly. Please be advised before changing commands.
Example When CS-CAN takes CESV command,
 SlllLDD... can be used instead of tlllLDD....
 VlllL can be used instead of TlllL.
Command H(R)
Description - Check if CAN frame was transmitted successfully by getting reply from RS232.
- After the setting is complete, when transmission of CAN frame is compete,
RS232 takes OK message.
- R  Response
0: Disable 1: Enable
Example When CS-CAN takes H1 command, it will send CAN frame and set RS232
to be ready to send OK.
Command SV
Description - Save all modified configuration
- You must save your settings after modifying.
Example When CS-CAN takes SV command, it will save all settings to the Flash
memory.