Solvline CS-CAN Command Manual - Manual (Page 13)

13
Progreamming Guide
3. Programming Guide
This page provides the information regarding how to modify configuration for
communication environments in serial and CAN.
3.1 How to set configuration for the serial communication
environment.
Order Command Description
Summary
Step 1. MO Send VA command to CS-CAN and check the current
mode in CS-CAN. If the returned syntax is OK0, then
the mode is in Configuration mode, but if it is OK1, then
it is in Active mode. If the mode is Configuration mode in CS-
CAN, please move to Step 3, but if the mode is Active Mode,
then proceed to Step 2.
Check current
mode in CS-CAN
Step 2 +++ Send +++ command to CS-CAN to change the mode to
Configuration mode. Modify
Configuration mode
Step 3 WS(BSP) Send WS command to CS-CAN and modify the serial
communication environment settings in CS-CAN. Modify serial
communication
environment
Step 4 SV Send SV command to CS-CAN and save the
configuration in CS-CAN. Save settings
Step 5 SR Reboot CS-CAN by sending SR command to CS-CAN.
Reboot CS-CAN