beautypg.com

SilentKnight VisorAlarm Plus 2U Operating Instructions User Manual

Page 6

background image

VisorALARM PLUS 2U System Overview

1 - 4

Doc.DM375-I

Ver. 1.0

echo packets towards this address fail then a code 356 alarm is generated from the Contact-ID protocol
(Loss of central polling). Default is 356.

In order to simplify installation and updating of the registered mIP/IPDACTs, the IP VisorALARM
PLUS 2U receiver has additional facilities.

To install new mIP/IPDACTs, the Teldat VisorALARM PLUS 2U holds configuration patterns
associated to installer passwords. These permit you to automatically register new mIP/IPDACTs in
the supported mIP/IPDACT list and at the same time enable the mIP/IPDACT to request the necessary
configuration for start up. The device can simultaneously have multiple patterns; the choice of one or
other depends on the installer password used in the mIP/IPDACT to request the service.

In order to maintain and update the registered mIP/IPDACTs base, the Teldat VisorALARM PLUS
2U has commands available to remotely update one or multiple configuration parameters used by the
mIP/IPDACTs.