SIG SAUER BLASER R93 - Manual (Page 19)

19
13.2 Removing the scope
- Grasp the rifle with your left hand
around the fore-end and scope,
steadying the rifle on your upper thigh.
- Loosen the two screws on the side of
the mount a few turns with an 1/8“
allen key.
- Remove the scope.
13. Mounting the fixed scope mount
13.1 Mounting the scope
- Loosen the two screws on the side of
the mount a few turns with an 1/8“
allen key.
- Grasp the centre tube of the scope
with the right hand above the mount.
- Hold the fore-end of the rifle with your
left hand and steady the stock against
your upper thigh.
- Carefully locate the two round locating
pins of the scope mount in the oval
notches milled into the top right of the
barrel. Tilt scope to the left and hold it
in that position.
- Tighten the two screws on the side of
the mount hand tight with an 1/8“
allen key.
Make sure the mounting faces are
clean and free of grease!
R93-Manual-english 08.01.2001 16:23 Uhr Seite 19