SIG SAUER BLASER R93 - Manual (Page 17)

17
10. Trigger assembly
The Blaser R 93 bolt action rifle is
equipped with a light and crisp trigger.
The trigger resistance is adjusted at the
factory to virtually the lightest setting
allowable under international safety
standards. The setting can and may only
be altered by the factory or by your
authorized Blaser dealer following factory
instructions.
11. Open sights
11.
(adjustable)
11.1 Front sight for height adjustment
- Insert the 1.5 mm AF allen key in the
hole of the mounting saddle in front
of the sight and turn the allen screw
in the appropriate direction:
- Front sight (spring-loaded)
screw out = point of impact lower
screw in = point of impact higher
11.2 Rear sight (notch) for side
adjustment
- The sight has holes left and right for a
1.5 mm allen key.
- To alter the point of impact
to the left
Undo the right stud screw, screw in
the left stud screw.
- To alter the point of impact
to the right
Undo the left stud screw, screw in the
right stud screw.
Screw the stud screws in with
sensitivity.
R93-Manual-english 08.01.2001 16:23 Uhr Seite 17