SIG SAUER BLASER R93 - Manual (Page 18)

18
english
- First thumb the front lever (fig. 22)
then the rear lever back and down as
far as they can go. If you need to apply
either no force or a lot of force when
doing this, then the mount is adjusted
wrongly. In either case, get your autho-
rized dealer to adjust it to the factory
specifications. The force required to
close the locking levers should be
about the same as that of the safety
slide.
- Now close the covers of both locking
levers.
Make sure the mounting faces are
clean and free of grease!
12. Mounting the telescopic sight
The R 93 barrels are equipped with
notches to accept Blaser QD scope mount
bases for 1“, 26 mm or 30 mm rings or
rail or Zeiss ZM rail. It is assumed that an
authorized dealer has fitted your scope
correctly to match the barrel.
12.1 Mounting the scope
- Flip open the covers of the front and
rear locking lever, then thumb these
fully up and forward.
- Take the center tube of the scope in
your right hand and hold it so that you
can reach the front lever with your
thumb (fig. 21).
- Grasp the stock with your left hand
and steady the stock against your
upper thigh.
- Carefully locate the two round locating
pins of the scope mount in the oval
notches milled into the top right of the
barrel. Tilt scope to the left and hold it
in that position.
12.2 Removing the scope
- Grasp the fore-end with the left hand
and steady the rifle on your upper
thigh.
- Flip open the covers of the two
locking levers.
- First release the rear locking lever
by thumbing it forwards as far as it
can go.
- Grasp the center tube of the scope
mount with the right hand.
- Now release the front locking lever by
thumbing it forwards and upwards as
far as it can go.
- Remove the scope upwards and to the
right.
fig. 21 fig. 22
R93-Manual-english 08.01.2001 16:23 Uhr Seite 18