Shellab SHO1-2 - Manual (Page 6)

Installation
6
Installation
Prepare the Site
Local city, county or other ordinances may govern the use of this equipment. If you have
any questions about local requirements, please contact the appropriate local agency.
The end user may perform installation, as it is unnecessary for this unit to be installed by
a technician.
Power source
The electrical supply circuit to the oven must conform to all national and local electrical
codes. Consult the oven's serial data plate (located on the top back panel of the oven)
for the voltage, cycle wattage, and ampere requirements before connecting to power. A
separate circuit is recommended to prevent possible loss of product due to overloading
or failure of other equipment on the same circuit. The supply voltage should not vary by
more than 10%.
Environment
Under normal circumstances, this unit is intended for use indoors at room temperatures
between 15 °C and 35 °C, and relative humidity between 15%
–85%. Contact Customer
Service if operating in conditions outside of these limits.
Location
In selecting a location, consider all conditions that might affect performance, such as
heat from radiators, ovens, autoclaves, etc. Avoid direct sun, fast moving air currents,
heating/cooling ducts, and high-traffic areas. Allow a minimum of 5 cm (2.0 in) between
the unit and walls or partitions, as they may obstruct free air flow.
Please read this manual before attempting to install the oven.
Section 2