Shellab SHO1-2 - Manual (Page 14)

Maintenance and Troubleshooting
14
Replacing the inline power fuse
The unit is protected by an inline fuse located behind the power cord. If needed, replace
the fuse as described below:
1. Turn off the oven and rotator, then disconnect from the power source.
2. Remove the power cord from the back of the oven.
3. Using a small, flat-bladed screwdriver pry the fuse holder from the back of the
unit. See Figure 8.
4. Inspect the fuse in service. See Figure 9. Replace if blown with a 6.3 A, 250 V
type T fuse.
If the inline power fuse blows repeatedly, check for the reason why. Check that the oven
is the correct voltage type, check the power cord, and check the power supply.