ScanTool STN1100 FRPM - Manual (Page 7)

Family Reference and Programming Manual
STN1100FRPMA www.obdsol.com 7 of 23
Command Description Status
CAF 0/1 Automatic formatting off/on* supported
CF hhh Set ID filter to hhh supported
CF hh hh hh hh Set ID filter to hh hh hh hh supported
CFC0/1 Flow control off/on* supported
CM hhh Set ID mask to hhh supported
CM hh hh hh hh Set ID mask to hh hh hh hh supported
CP hh Set CAN priority to hh (29 bit only) supported
CRA hhh Set CAN receive address to hhh supported
CRA hh hh hh hh Set CAN receive address to hh hh hh hh supported
CS Show CAN status counts supported
D 0/1 Display of the DLC off*/on supported
FC SM h Flow control, set mode to h supported
FC SH hhh Flow control, set header to hhh supported
FC SH hh hh hh hh Flow control, set header to hh hh hh hh supported
FC SD [1-5 bytes] Flow control, set data to […] supported
RTR Send an RTR message supported
V 0/1 Use of variable DLC off*/on supported
J1939 CAN Specific Commands (protocols A to C)
Command Description Status
DM1 Monitor for DM1 messages supported
JE Use J1939 ELM data format* supported
JS Use J1939 SAE data format supported
MP hh hh Monitor for PGN 0hhhh supported
MP hh hh hh Monitor for PGN hhhhhh supported
Note 1: ID string corresponds to the version of the ELM327 IC that STN11xx is designed to be compatible with (e.g.,
“ELM327 v1.3a”).
Note 2: Device description string can be modified using STS@1 command.