ScanTool STN1100 FRPM - Manual (Page 6)

STN1100
6 of 23 www.obdsol.com STN1100FRPMA
OBD Commands
Command Description Status
AL Allow long (>7 byte) messages supported
AR Automatically receive supported
AT 0/1/2 Adaptive timing off, auto1*, auto2 supported
BD Buffer dump not applicable
BI Bypass initialization sequence supported
DP Describe current protocol supported
DPN Describe current protocol by number supported
H 0/1 Headers off*/on supported
MA Monitor all supported
MR hh Monitor for receiver hh supported
MT hh Monitor for transmitter hh supported
NL Normal length messages* (7 bytes max) supported
PC Protocol close supported
R 0/1 Responses off/on* supported
RA hh Set the receive address to hh supported
S 0/1 Print spaces off/on* supported
SH hhh Set header to hhh supported
SH hh hh hh Set header to hh hh hh supported
SP h Set protocol to h and save it supported
SP Ah Set protocol to h with auto search and save it supported
SR hh Set receive address to hh supported
ST hh Set timeout to hh x 4 ms supported
TP h Try protocol h supported
TP Ah Try protocol h with auto search supported
J1850 Specific Commands (protocols 1 and 2)
Command Description Status
IFR 0/1/2 IFRs off, auto*, or on supported
IFR H/S IFR value from header* or source supported
ISO Specific Commands (protocols 3 to 5)
Command Description Status
IB 10 Set ISO baud rate to 10400* supported
IB 96 Set ISO baud rate to 9600 supported
IIA hh Set the ISO (slow) init address to hh supported
KW Display ISO key word supported
KW 0/1 Key word checking off/on* supported
SW hh Set wakeup interval to hh x 20 ms supported
WM [1-6 bytes] Set wakeup wessage supported
CAN Specific Commands