ScanTool USB to Bluetooth Adapter Windows XP/Vista - Manual

Introduction
This manual explains how to install and configure
the USB to Bluetooth adapter on your Windows
XP or Windows Vista PC.
1.
.
2.
you may need it later to configure the diagnostic
software.
The Bluetooth Devices window will appear:
The Add Bluetooth Device Wizard will appear: The Wizard will connect to the scan tool, and
exchange passkeys:
Plug in the Adapter
Plug the USB-to-Bluetooth Adapter into any
available USB port. Windows will locate and
install the drivers
Check the My Device is set up and ready to be
Once the passkeys are exchanged the wizard will found check box, then click the Next > button. Set up the Bluetooth Connection
display the COM port numbers:
The Wizard will search for and display Bluetooth Locate the “Bluetooth Devices” icon in the
devices within range: system tray:
Double-click the icon.
Click on the ScanTool.net-XXXX icon, then click
Click Finish. the Next > button.
The wizard will close and you should see You will be asked to enter your passkey:
ScanTool.net-XXXX under the All other devices
view:
Select the Use the passkey found in the
documentation: radio button. Enter 1234 in the
text box then click Next >
Click the Add… button.
Click OK to complete setup process.
If the icon does not appear in the system tray,
remove and re-insert the USB-to-Bluetooth
adapter.
Write down the number of the outgoing COM port,
Windows XP/Vista: Installing USB to Bluetooth Adapter