Reznor Carryover Lighter Tube Parts Manuals - Manual (Page 2)

Form RZ-NA-P-X/XE-LTR-TUBE, Page 2
INSTALL LIGHTER TUBE (cont'd) - Steps 1-6 apply both natural and propane gas heaters.
3. Slide lighter tube into the holes provided. Ensure pin
holes in the tube are facing outward toward the
burner tubes.
5. Install drip shield. NOTE: "Z" effect when observed from the
side. Compress lighter tube into half circle cutouts in the burner
tubes. Be sure the tube is seated. The 90
o angle on the drip
shield should be against the top and side of the burner rear
plate.
6. Install the drip shield screws to secure the
drip shield. Reverse Step No. 2 on page 1.
4. Using two screws, secure the lighter tube to the
burner rack.
INSTALL LIGHTER TUBE GAS CONNECTIONS - Steps 7-11 apply to Natural Gas Units
ONLY
7. Remove the pipe plug from the manifold. 8. Install the 90° elbow and position as illustrated.